Kit 3 - Mitsubishi 3-gauge
This kit is designed to run the gauges above. These are the Mitsubishi branded Lamco gauges that can be found in many of the variants across the Lancer evolution series 1-9 equipped with the 4G63T engine (1992-2007). Owners may also install them on the earlier Galant VR-4 (1987-1993). The kit will support all of these types.
Sensor and harness kit
The kit below contains everything you need to get bare gauges running. No OEM wiring is used. Kit includes sensors, adapters, heat shielded sensor wiring with plugs installed, and a main harness with gauge plugs. All you need to do is install everything and connect 3 additional wires to the harness terminal. These are 12V+ switched, GND and 12V+ headlight which can be obtained from the radio harness. (Gauges not included.)
Kit contents
1 x AEM temperature sensor (AEM 30-2012)
2 x 3m sensor wire looms with sensor plugs installed
2 x 2.5m fiberglass Insultherm heat shielding preinstalled on sensor wires (650C rated)
1 x 700mm custom gauge harness with labelled 5pin plugs and terminal
1 x 2 pin flying plug for illuminating boost gauge (can be unused if not required)
Installation
Step by step installation guide is coming soon. Special note that customers have confirmed installation of the oil temp sensor (which is a 1/8NPT taper thread) into the 4G63T engine directly. You can also use oil filter relocation kits (pictured above) which often have sensor ports pre-drilled, but this is not necessary.
Quality Assurance
I hand assemble and test each kit thoroughly before shipping. This includes bench testing the entire kit end-end from sensor to gauge pins. I record these test videos and provide a personal video overview to each and every customer, along with build photos.
Price
The complete sensor and harness kit (excluding gauges) is priced at $300 USD + postage. Postage is typically ~30USD shipped anywhere in the world via premium tracked international courier.
Payment and Shipping
I have a business Paypal account, facilitating easy payment with buyer protection, which is the most preferred method. I also have a WISE account (formerly TransferWise) with bank accounts in most currencies. Build time is usually 3-5 days and shipping via international courier is typically 3-10 business days.
What is the process to get a kit? (I'll quote first to ensure you get the right kit)
To ensure you get the right kit for your car, I don't sell directly via the website. Instead I use a quote-order process where you contact me (via the contact button below) and provide details of your setup. Once I have your details I can email you a quote with a final price including shipping to your door. The quote contains options for payment via Paypal if you decide to proceed. Once I receive payment I'll confirm receipt, and begin assembling your kit. Once it's tested I'll ship it and send you an email with the tracking information, along with build photos and a personalised video fly over of your harness on the test bench.